Telephone base installation
Install the telephone base as shown below.
Electrical outlet 
(not controlled
by a wall switch)
Telephone base 
power adapter
Telephone wall jack
A DSL filter (not included) is
required if you have DSL
The DSL filter must be plugged into the telephone wall jack.
Telephone line cord
•Use only the power adapter and battery supplied with this product. To order a replacement, visit our website at www.vtechphones.com or call 1 (800)
•Even if you do not subscribe to any conventional telephone service, you can still use the cell line alone without plugging in a telephone line cord.
•If you subscribe to telephone service from a cable company or a VoIP service provider, contact your cable/VoIP service provider for more information.
Battery installation
Install the battery as shown below.
. Insert the battery connector securely into the socket as shown below.
2.Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES. Made in China / Fabriqué en chine 
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack /
(2.4V
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES. Made in China / Fabriqué en chine 
3. Slide the battery compartment cover | . Place the handset on the telephone |
towards the center of the handset | base to charge. |
until it clicks into place. |
|
BASE
10:01 12/08 | 9 |
displays when charging.
IMPORTANT:
Check for a dial tone by pressing 
. If you hear a dial tone, the installation is successful.
If you do not hear a dial tone:
•Make sure the installation procedures described above are properly done.
•It may be a wiring problem. If you have changed your telephone service to digital service from a cable company or a VoIP service provider, the telephone line may need to be rewired to allow all existing telephone jacks to work. Contact your cable/VoIP service provider for more information.
