Getting Started
Installation of Battery Pack in Handset
Follow the steps below:
1 1. Remove the battery cover by pressing on the indent and sliding downward.
3 | 2. | Place the new battery pack in the |
|
| handset with the metal contacts |
|
| aligned with the charge contacts |
|
| in the battery compartment. |
3. Replace the battery cover by sliding it upwards.
4. If the new battery pack is not already charged, place the handset in the base unit, or a remote charging stand, and allow it to charge for 12 hours. After initial charge, a maintenance
2charge of 8 hours should be sufficient.
The original Handset that is shipped with your QW2432 system will be automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension numbers in the following order: HANDSET 2, HANDSET 3, and finally HANDSET 4.
Whenever a Handset battery pack is installed, the Handset will automatically begin SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER BASE ID to register the new Handset.
8
