VTech VT1940 manual Replacing the Battery Pack, Its ImpossibleTo Overcharge The Battery Pack

Models: VT1940

1 18
Download 18 pages 45.2 Kb
Page 7
Image 7

REPLACING THE BATTERY PACK

REPLACING THE BATTERY PACK

ChargingThe Handset Battery Pack The handset of your VTech VT 1940 cordless telephone is powered by a rechargeable battery pack. It charges automatically whenever the handset is in the base. You should charge the battery packfor 16 hourswhen you first receive your phone. You'llknow the battery pack needs charging when:

The phone emits a warning tone when you press the PHONE key.

The base spare battery charger does NOT charge a battery pack as quickly as the handset battery charger. A full charge requires 24 hours when using the spare battery charger.

It's ImpossibleTo Overcharge The Battery Pack

The battery pack can be recharged many times, but if you get a low battery message even after 16 hours of charging in the base cradle (or 24 hoursinthe basespare batterycharger),

To Replace The Handset Battery Pack Follow The Steps Below:

1.Remove the batterv case cover by pressing on the ridged lines and sliding downward.

PRESS and SLIDE

DOWNWARD

SLIDE IN THE BATTERY COVER

The MUTEJLOW BATT LED is slowly flashing.

The handset seems completely dead and does not beep when you press the keys.

To Charge The Battery Pack

To charge the battery pack, place the handset in the base unit. The charging indicator will light to show the handset is seated properly and the battery pack is charging. It is recommended that the battery pack be charged for at least 16 hoursinitiallyand 8 hoursfor maintenance charging. You can use your telephone before that with diminishedcapacity, but it is best to charge the battery pack fully. It will take several recharge cycles to maximize the charge capacity of your battery pack. The maximum battery life betweenchargesis7 hoursof continuous talk time or 7 days of stand- by.

Alternatively, if you have purchased a spare battery pack and it has been charginginthe base unit,simply exchange the drained handsetbattery packwith the fully charged replacement battery pack from the basecharger. Placethe drained handsetbatterypackintothe basecharger to recharge.

the battery pack(s) should be replaced.

To purchase replacement battery packs, call VTECH Communications at 1-800-595-9511. In Canada, call VTECH Electronics at 1-800-267- 7377.

AWord About RechargeableBatteries Your Nicad battery pack recharges whenever the Handset is returned to the Base Unit cradle. You may return the Handset to its cradle whenever you'renot using the phone.

2.Discard the old battery pack. Don't

put the old battery pack in a trash compactor or a fire - it could burst.

3.Place the new battery pack in its housing with the metal contacts facing down.

PLACE THE NEW BATTERY PACK lNTO THE BATTERY COMPARTMENT

PLEASE NOTE THE

CORRECT POSITION

OF THE BAlTERY

PACK WHEN

CHANGING BAlTERY

4.Replace the battery case cover by sliding the cover upwards.

5 . If the new battery pack is not already charged, place the hand- set in the cradle of the base unit to allow it to charge for 16 hours.

CAUTION:

To Reduce the Risk of Fire or Injury to persons, read and Follow the Instructions

1.Use only VTECH rechargeable battery pack.

2.Do not dispose of the battery in a fire. The cell may explode.

IMPORTANT:

Do not dispose of this battery into household garbage. For informationon recycling or proper disposal, consult your local solid waste collection or disposal organization.

3.Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

4.Exercise care in handling batter- ies in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns.

Page 7
Image 7
VTech VT1940 manual Replacing the Battery Pack, Its ImpossibleTo Overcharge The Battery Pack, To Charge The Battery Pack