GETTING STARTED
Check for a dial tone. After the battery pack is charged, rotate the Base Unit antenna to an upright
position. Pick up the Handset and press(^). You will hear a dial
tone. If not, see 'INCASE OF
DIFFICULTY'.
Fill in the telephone number card on the base unit.
FILL IN THE
TELEPHONE
NUMBER CARD
CAUTION:
1.Never install telephone wiring during a lightning storm.
2.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3.Nevertouch uninsulatedtelephone wires or terminals unless the telephone line , has been disconnected at the network interface.
4.Use caution when installing or modifying telephone lines.
.*
e
WALL MOUNTING
The Wall Mountingbracket is designed to fit on standardWall Mountingplates.
1.Choose a spot near an electrical outlet and a telephone jack. Your phone requires a modular telephone jack and a standard electrical outlet (120v AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the base. The outlet should not be controlled by a wall switch. If the switch is ever turned off, the phone will not operate.
2.Position the wall mounting bracket on the base.
Line up the tabs on the wall mounting adapter with the holes on the bottom of the base (Figure 1). Snap the wall mounting bracket firmly in place.
Mount the base on the wall. Position the base so the mounting studs will fit into the holes on the bottom of the base. Position the power cord to extend down the wall the phone is to be mounted o'n.Slide the base down on the mounting studs until it locks into place.
4.Connect the telephone line cord. The telephone line cord has a
Figure 1
5.Plug the AC adapter into an electrical outlet and the DC connecter into the power jack
located on the back of the Base Unit .(Figure 2)
Figure 2
