VTech VT20-2420 user manual Getting Started, Installation of Battery Pack in Handset

Getting Started Setup

Registration And Operation Of The VTECH VT20-2420 Accessory Handset

Your VTECH 2-Line GIGAPHONE system can operate up to 8 Handsets. The VTECH accessory Handset consists of the following:

L1	OFF	L2
FLASH	CLEAR		FLASH
1	2 ABC	3	DEF
4 GHI	5 JKL	6	MNO
7 PQRS	8 TUV	9 WXYZ
* TONE	0 OPER	#
HANDSFREE	INTERCOM/		VOLUME
	TRANSFER
2.4GHz	GIGA PHONE

Handset Belt Clip Battery Pack Charger Unit

Installation of Battery Pack in Handset

		Follow the steps below:
1		1.	Remove the battery cover by pressing
	3	2.	on the indent and sliding downward.
			Place the new battery pack in the
			handset with the metal contacts
			aligned with the charge contacts in
		3.	the battery compartment.
			Replace the battery cover by sliding
		4.	it upwards.
			If the new battery pack is not already
			charged, place the handset in the
			base unit, or a remote charging
			stand, and allow it to charge for 12
			hours.	After initial charge, a
	2		maintenance charge of 8 hours
			should be sufficient.

1

3

5

L1	OFF	L2
FLASH	CLEAR	FLASH

12 ABC 3 DEF

4 GHI	5 JKL	6	MNO
7 PQRS	8 TUV	9 WXYZ
* TONE	0 OPER	#

HANDSFREE INTERCOM/ VOLUME

TRANSFER

2.4GHz GIGAPHONE

Setup Of The VT20-2420 Accessory Handset

1. Plug the AC power adapter into an electrical outlet.

2. Remove the Handset battery cover by pressing on the indent and sliding downward.

3. Place the new battery pack in the Handset, with the metal contacts aligned with the charge contacts in the battery compartment.

4. Replace the battery cover by sliding it upward.

5. Place the Handset in the Charge Cradle, and allow it to charge for 12 hours. After the initial charge, a maintenance charge of 8 hours should be sufficient.

The original Handset that is shipped with you 2-Line GIGAPHONE system will be automatically registered to the Base. This Handset is HANDSET 1.

As you register additional Handsets to the system, they will be assigned extension numbers in the following order: HANDSET 2, HANDSET 3, HANDSET 4, and so forth.

Whenever a Handset battery pack is installed, the Handset will automatically begin SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER BASE ID to register the new Handset.

BEFORE USING YOUR HANDSET(S), CAREFULLY PEEL OFF THE PROTECTIVE FILM, COVERING THE DISPLAY.

4 5