Vulcan-Hart 1GR35M, 1GR45M, 1GR65M, 1GR85M, 2GR45MF, 2GR65MR, 2GR85MF, 2XG45MF, 2XG65MF, 2XG85MF, 3GR45MF, 3GR65MF, 3GR85MF, 4GR45MF, 4GR65MF, 4GR85MF, ML-13, ML-136407, ML-136408, ML-136409, ML-136410, ML-136417, ML-136418, ML-136419, ML-136420, ML-136421, ML-136422 LIGHTING THE PILOT ,

GRM SERIES GAS FRYERS

VULCAN-HART F-312 33 Rev. F (January 2008)

-11-

LIGHTING THE PILOT

A Thermostat Knob

B Gas Control Handle

1. Open the door.

2. Turn the thermostat to OFF (see figure below, view A). The thermostat is located

behind the door.

3. Push the gas control valve knob and turn to OFF. Wait 5 minutes for unburned gas

to vent.

4. Push and turn gas control valve knob to the “L” in PILOT (see figure below, view B).

5. While still holding the knob in, light the pilot with a lit flame. Continue to depress

the knob until pilot remains lit when knob is released. If the pilot does not remain lit,

repeat step 3 through 5.

6. Depress and turn gas control knob to ON (See figure below, view C).

7. If gas supply is interrupted, repeat steps 2 through 6.

Contents

Main INSTALLATION & OPERATIONAL MANUAL GRM SERIES GAS FRYERS MODELS: IMPORTANT FOR YOUR SAFETY IMPORTANT FOR YOUR SAFETY -3- TABLE OF CONTENTS INTRODUCTION ORDERING PARTS UNPACKING INSTALLATION CODES AND STANDARDS ASSEMBLY FLUE CONNECTION GAS CONNECTION Page LEVELING THE FRYER OPERATION OVER-TEMPERATURE SHUTDOWN BEFORE FIRST USE FILLING TANK WITH SHORTENING LIGHTING THE PILOT TURNING ON THE FRYER TURNING OFF THE FRYER EXTENDED SHUTDOWN BASIC FRYING INSTRUCTION EXTENDING SHORTENING LIFE DRAINING THE TANK DAILY FILTERING CLEANING BOIL OUT PROCEDURE Page Page Page -19- INSTRUCTIONS TO REMOVE & REPLACE KLEENSCREEN PLUS FILTER ENVELOPE DO NOT WASH FABRIC ENVELOPE Operation Fig. 5 Page F i g . 6 Fig. 7 MAINTENANCE FLUE VENT INSPECTION

Vulcan-Hart LIGHTING THE PILOT ,