LEG STAND ASSEMBLY
INSTRUCTIONS
Required Tools
7/16" Socket
Philips Head Screw Driver
13/16" Open End Wrench
Leg | Screw |
assembly | Nut |
| |
| w/ |
| Lock |
| washer |
Shelf |
|
Figure 1
1.Insert short end of leg into top of shelf (Fig. 1).
2.Secure into place with one (1) screw, one
(1) lock washer, and one (1) nut per hole.
3.Repeat leg installation with three (3) remaining legs.
casters |
(rear) |
Locking casters |
(front) |
Figure 2
4.Install the two (2) front locking casters into the short end of the leg assembly (Fig. 2).
5.Install the rear
Tighten nut |
Figure 3
6.Secure all four (4) casters by tightening down the nut on the underside of the caster.
7.Ensure the two locking casters are located on the same side of the stand. This will now be the front of the broiler.
BROILER STAND INSTALLATION
Required Tools
13/16" Open End Wrench
1.Lower Broiler onto the four (4) legs of the stand, supporting from under the body bottom (Fig. 4).
Figure 4
— 5 —
