2)Insert the battery pack into the charger, as shown in Fig 7, making sure the pack is fully seated in the charger. The red light indicator will illuminate showing that the battery is being charged.
3)When charging is well done green light will illuminate. The minimum charge time is normally 1hour after which the battery should be removed.
IMPORTANT CHARGING NOTES
Longest life and best performance can be obtained if the battery pack is charged
when the air temperature is between 65ºF - 75ºF. Do not expose charger to water, rain or snow.
1)The charger and battery pack may become warm to touch while charging. This is a normal condition and does not indicate a problem.
2)The charger has an internal temperature limit that, when exceeded, will temporarily stop the full charge current. This is indicated by the green light being ON. The normal charge cycle will resume when the temperature falls below the present limit and will be indicated by the red light turning ON. To prevent overheating, do not cover the charger and do not charge battery packs in direct sunlight or near heat sources.
3)During normal use the internal temperature of the battery pack may rise. If the battery pack is being used and then immediately put into the charger for recharging, the temperature might be too high and the green light will turn ON indicating that the cut off temperature has been exceeded. In this situation let the battery cool down. The charging cycle will come back on automatically after the temperature cooled down. This will be indicated by the red light turned ON.
4)If the battery pack does not charge properly 1) Check current at
receptacle by plugging in a lamp or other appliance. 2) Check to see if receptacle is connected to15a light switch which turns power off when
you turn out the light. 3) Move charger and battery pack to a location where the surrounding air temperature is approximately 65ºF - 75ºF
5)The battery pack should be recharged when it fails to produce sufficient power on jobs which were done previously. DO NOT CONTINUE to use under these conditions. Follow the charging procedure. You may also charge a partially used pack whenever you desire with no adverse affect on the battery pack.
6)Under certain conditions, with the charger plugged in to the power supply, the exposed charging contacts inside the charger can be shorted by foreign material. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.
7)Do not immerse charger in water or any other liquid.
8)WARNING: do not allow any liquid to get inside charger. Electric shock may result. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed or an
9)CAUTION: never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service center for recycling.
ASSEMBLY
REMOVING OR INSTALLING THE BLADE
CAUTION:
16
Always be sure that the tool is switched off and the battery cartridge is remove
