AEG 5071 manual Installation And Connection Instructions, Installing the Dishwasher

Installation and Connection Instructions

INSTALLATION AND CONNECTION INSTRUCTIONS

Installing the Dishwasher

•The dishwasher must be installed on a firm floor and adjusted such that it is stable and level.

•Using the spanner supplied, extend the threaded feet to compensate for unevenness in the floor and to adjust the height of the appliance to suit the surrounding units. In the case of dishwashers that can be built-in or integrated, the rear feet on the appliance are adjusted at the front of the appliance using a screwdriver.

•The drain hose, inlet hose and mains cable must be laid such that they are free to move in the rear of the plinth recess, so that they cannot be kinked or crushed.

•In addition, the dishwasher must be firmly screwed to the work sur- face or to the neighbouring units. This is essential to guarantee the tipping security required by VDE regulations.

•Depending on type, the dishwasher is to be installed as follows:

Dishwashers That Can Be Integrated

(see installation stencil supplied)

3The door of the appliance can be fitted with a wooden/facing panel of the following dimensions:

Width:	591 – 594 mm
Thickness:	16 – 24 mm
Height:	max. 600 mm	– Recess height
	depending on	– Plinth height
		– Adjustment to match the joint on the neighbouring
		units
Weight:	max. 8 kg

1If the facing panel is longer than 600 mm, the door of the appliance cannot be fully opened (the facing panel will foul on the plinth).

In this case a cut-out must be made in the plinth (see installation sten- cil) or the stop kit for a door of excess length, BLT 60, used. You can obtain this under E-No. 911 239 008.

30