AEG 5071 Built-In Dishwasher, Free-Standing Appliances, see enclosed installation instructions

	Installation and Connection Instructions
	Built-In Dishwasher
	(see enclosed installation instructions)
	Free-Standing Appliances
1	• Can be installed free-standing without additional fixings.
	If the dishwasher is installed next to a gas or solid fuel cooker, a non-

flammable panel of thermal insulation must be fitted between the cooker and the dishwasher, the panel must flush with the upper edge of the work surface (depth 57.5 cm). The panel should be fitted with aluminium foil on the side facing the cooker.

•If the dishwasher is to be built-in under a kitchen work surface, the work surface fitted to the dish- washer must be removed as fol- lows:

–Undo the screws on the angled brackets on the rear of the appli- ance (1).

–Slide the work surface approx. 1cm to the rear (2), lift at the front (3) and remove.

–Press the work surface retaining brackets at the position shown in the diagram (4) and remove the bracket at an angle to the rear (5).

1 If the dishwasher is subsequently used as a stand-alone unit again, the work surface must be re-fitted.

4

5

31