AEG 5071 manual Start the wash programme, Changing/Interrupting/Cancelling the Wash Programme

Operating instructions

Start the wash programme

01. Check that the dishes and cutlery are loaded into the dishwasher in such a manner that the spray arms are free to rotate.

2.Open the tap fully.

3.Shut the door.

4.Press the On/Off button M. The On/Off button Mindicator illumi- nates.

5.Press the programme button for the desired programme (see "Pro- gramme Table"). The programme indicator illuminates. The selected programme begins after around 6 seconds. The time remaining until the end of the programme is displayed on the multi-display, the time calculated is dependent on the load in the dish racks.

3If fault messages are displayed on the multi-display after the start of the programme, please read the "What to do, if..." section.

Changing/Interrupting/Cancelling

the Wash Programme

3Only change or interrupt a wash programme in progress if it is abso- lutely necessary to do so. When the appliance is closed again, the air that has entered is heated and expands significantly. As result water may penetrate into the base of the appliance and trigger the leak pre- vention system.

Changing the wash programme

3If you want to change the wash programme within 6 seconds of mak- ing a programme selection, briefly press the button for the new wash program.

If you want to change the wash programme at a later point in time, use the following procedure:

01. Press the button for the new wash programme and hold it pressed. The indicators for both programmes now flash.

2.After a few seconds only the indicator for the new programme flashes. Release the programme button, the new programme is now running.

22