FRONT PANEL CONTROLS
INPUT | socket to plug in a bass guitar. |
GAIN | control + CLIP LED to adjust the input level*. |
switch to set the range of the GAIN control. Use it with high output basses. | |
COMPRESSOR | switch + |
| In position up the compressor is on, in middle position off, in down position it is |
| on if the EQ section is activated. |
COMPRESSION | control to set the compression ratio. |
BOOST | switch to activate a second volume level. In down position +2dB, in up position |
| +6dB, in middle poistion the boost is off. Activating the BOOST does automatic |
| ally activate the Compressor.* |
EQ ON | switch activates the EQ section*. |
EQ BALANCE | control to balance the volume level with EQ on and EQ off.* |
VOICING SECTION:*
BOTTOM | control to extend the low frequency range. Use this at lower volume settings or for |
| ultra low sounds. At higher volumes it might be better to reduce the low range. |
CONTOUR | control boosts lows and highs, while cutting mids. |
GROWL | control for boosting/cutting low mids. |
TREMECLIP point. | control for boosting/cutting presence. |
ATTACK | |
EQ SECTION:* |
|
BASS | control to boost/cut deep frequencies. |
MID FREQ. | control to determine a frequency. |
MID LEVEL | control to boost/cut the frequency adjusted with the MID FREQ. control. |
TREBLE | control to boost/cut high frequencies. |
MUTE | switch + ON/MUTE LED cuts the signal from all outputs, except from the PHONES |
| socket, and activates the TUNER output (rear panel). In case of signal flow at the |
| power section (Input or Effects Return), there might appear a popping noise when |
| MUTE is switched. To avoid this, mute your strings and have effects like delays |
| muted when switching MUTE. |
MASTER | control determines the mains level. |
PHONES | socket for connecting a headphone (min 200 Ω) |
POWER | on/off switch for the Mains Power. |
* Note: after adjusting the voicing section, the BOOST or activating the EQ section the Gain control needs to be adjusted that the level is under the | |
X- |
|
