![](/images/new-backgrounds/1148928/14892825x1.webp)
Setup & Configuration
—Scanning Modes
The 'Scanning Mode' option controls the trigger and LED settings for the WLP 4170 CCD Scanner.
NOTE: For help in configuring these settings, consult the programming steps on page 5.
Begin
00
Set Scanning Mode
Default*
04 Continuous
Continuous Mode
When this option is selected, the LEDs are visible at all times. Under this option, you cannot read the same bar code
* Trigger with 10 Sec. Delay
This is the default option for the Wasp WLP 4170 CCD Scanner. When this option is selected, the scanner will stop scanning when there is a successful read or no code is scanned after 10 seconds.
Exit
*Default
10