Chapter 5
Setup & Configuration
In order to configure Wasp WLP 4170 CCD Scanner, you must familiarize yourself with the setup procedures on the following pages. The default settings of Wasp WLP 4170 CCD Scanner are identified on each page and clearly marked using an asterisk (*). The default settings have been preprogrammed for the most common bar code configurations. Use the Setup & Configuration only to customize the Wasp settings. If you need to configure Wasp WLP 4170 CCD Scanner, the default settings will be overwritten.All the programmed settings are stored permanently in
In order to configure Wasp WLP 4170 CCD Scanner, seven basic steps need to be followed for each programmed setting:
(1)Determine what, if any, options on EACH PAGE that you wish to change.
(2)Scan the "Begin" bar code. WLP 4170 CCD Scanner will sound an ascending tone to indicate that setup is in progress.
(3)Scan the bar code representing the option to be changed.
(4)Scan the bar codes representing the option values (e.g. 01, 02, 3A etc.). These option values can be found on the inside back cover flap of this manual. You must scan two digits for each option setting.
(5)Repeat the above two steps, if necessary, to change the options in the same group.
(6)Scan the “Set”bar code on the back cover flap to confirm your selections.
(7)Scan the "Exit" bar code to exit the group currently selected. Wasp WLP 4170 CCD Scanner will sound a descending tone.
NOTE: Pages 6 and 7 are designed as walk through example pages. Use these pages as examples on how to change an option for the rest of the manual.
5
