WatchGuard Technologies manual Firebox V10, V60, V60L, V80, and V100 Components, AC Power Cord

Firebox V10, V60, V60L, V80, and V100 Components

AC Power Cord

Enables you to connect the appliance (using the supplied power cord) to a 100 to 240VAC (50/ 60Hz) power source. The power supply can auto- detect 110/220 voltage.

Power Supply Switch

Allows you to turn the appliance on or off.

UPS Port

Allows you to use the RS-232 cable provided in the package to connect the appliance to an Uninterruptable Power Supply (UPS). This type of connection enables UPS devices to notify the appliance if the power goes out, prompting the appliance to shut itself down properly.

UPS devices from American Power Company (APC) are currently supported by the Firebox

Vclass power management firmware. Check the WatchGuard Web site (www.watchguard.com) for

updated information on complete UPS support.

NOTE

In the event of a power failure, this security appliance, if left connected to the power source, will automatically restart itself after electrical power has been restored. You do not have to press either the Power button on the front or the power supply switch on the back of the appliance.

Firebox V10, V60, V60L, V80, and V100 Components

Every appliance has three sets of components:

RapidCore™ hardware ensemble

Awell-integrated chip set and memory system powers every Firebox Vclass appliance in its

Firebox V10, V60L, V60, V80, V100 Hardware Guide 11