Watlow Electric 2000 - page 10

8■ Watlow MINICHEF 2000 Application 7
With Sound set to 0, the controller automatically switches to idle in which the con-
troller does not maintain temperature and does not run time. [`idle] or time of
day will appear on the display. The menu key indicator light will be off.
With Sound set to 1, 2, or 3, [``end] will appear on the display and an audible tone
will be emitted. The menu key indicator light will flash rapidly. You can acknowl-
edge the tone by pressing the active menu key or it will time out in 1 to 20 seconds
and go into idle. The menu key indicator light will flash slowly.
With Sound set to 4 or 5, end will appear on the display and the menu key indicator
light will flash rapidly. You must acknowledge the audible signal by pressing the
active menu key. Once acknowledged the audible signal is silenced and the con-
troller goes into idle. The menu key indicator light will flash slowly.
4. Once the controller goes into idle, the menu key indicator light and the heat outputs
will switch off. The controller will not regulate to any temperature.
5. To repeat cooking, repeat steps 1 through 2 or 3.
Run a Menu (when preheat feature is not active)
This procedure describes how to run an active menu when the preheat feature is inac-
tive - in other words, when the [ready] parameter in the [setUp] function of the
Configuration mode is set to [```no].
1. With idle on the display, place the food in the oven.
2. Press the key for the menu you want to run.
The menu key indicator will light up. Time will count down on the display.
The unit will run the following four-step cooking sequence:
Countdown time is displayed. It is the total of the programmed Time 1 plus Time 2
plus Time 3 plus Time 4.
Set point 1 and Fan 1 will run until Time 1 expires.
Set point 2 and Fan 2 will run until Time 2 expires. You will not see the switch-over
from Time 1 to Time 2.
Set point 3 and Fan 3 will run until Time 3 expires. You will not see the switch-over
from Time 2 to Time 3.
Set point 4 and Fan 4 will run until Time 4 expires. You will not see the switch-over
from Time 3 to Time 4.
3. When the cooking sequence is finished, one of the following will happen, depending
on the way the controller was programmed at [Etype] / [sound]:
With Sound set to 0, the controller automatically switches to idle in which the con-
troller does not maintain temperature and does not run time. [`idle] or time of
day will appear on the display. The menu key indicator light will be off.
With Sound set to 1, 2, or 3, [``end] will appear on the display and an audible tone
will be emitted. The menu key indicator light will flash rapidly. You can acknowl-
edge the tone by pressing the active menu key or it will time out in 1 to 20 seconds
and go into idle. The menu key indicator light will flash slowly.
With Sound set to 4 or 5, end will appear on the display and the menu key indicator
light will flash rapidly. You must acknowledge the audible signal by pressing the
active menu key. Once acknowledged the audible signal is silenced and the con-
troller goes into idle. The menu key indicator light will flash slowly.