Watlow Electric 2000

18 ■ Watlow MINICHEF 2000 Application 8

With Sound set to 0, the controller automatically switches to idle in which the con-

troller does not maintain temperature and does not run time. [`idle] or current

time will appear on the display. The Start/Stop key indicator light will be off.

With Sound set to 1, 2, or 3, [``end] will appear on the display and an audible

tone will be emitted. The Start/Stop key indicator light will flash rapidly. You can

acknowledge the tone by pressing the Start/Stop key or it will time out in 1 to 20

seconds and go into idle. The Start/Stop key indicator light will be off.

With Sound set to 4 or 5, [``end] will appear on the display and the Start/Stop

key indicator light will flash rapidly. You must acknowledge the audible signal by

pressing the Start/Stop key. Once acknowledged the audible signal is silenced and

the controller goes into idle. The Start/Stop key indicator light will be off.

5. Once the controller goes into idle, the Start/Stop key indicator light and the heat

outputs will switch off. The controller will not regulate to any temperature.

6. To repeat cooking, repeat steps 1 through 3 or 4.

Run a Menu (when preheat feature is not active)

This procedure describes how to run an active menu when the preheat feature is inac-

tive - in other words, when the [ready] parameter in the [setUp] function of the

Configuration mode is set to [```no].

1. Select a menu as shown earlier.

2. With [`idle], time of day or a menu number on the display, place the food in the

oven.

3. Press the Start/Stop key.

The Start/Stop key indicator will light up. Time will count down on the display.

The unit will run the following four-step cooking sequence:

Countdown time is displayed. It is the total of the programmed Time 1 plus Time 2

plus Time 3 plus Time 4.

Set point 1 and Fan 1 will run until Time 1 expires.

Set point 2 and Fan 2 will run until Time 2 expires. You will not see the switch-over

from Time 1 to Time 2.

Set point 3 and Fan 3 will run until Time 3 expires. You will not see the switch-over

from Time 2 to Time 3.

Set point 4 and Fan 4 will run until Time 4 expires. You will not see the switch-over

from Time 3 to Time 4.

4. When the cooking sequence is finished, one of the following will happen, depending