Application 7 Watlow MINICHEF 2000 ■ 7
The heat output indicator light - G, just below the display- will light up whenever
the controller is calling for heat.
When the oven is at operating temperature (above the relative set point minus the
ready band) [ready] will appear on the display and the menu key indicator light
will flash rapidly. You are now ready to cook with the active menu.
• If the oven is at operating temperature, the display goes directly to [ready] with-
out indicating preheat or temperature.
Note: you can skip preheat and go directly to the cooking sequence by pressing the menu key a second time.
Run a Menu (when preheat feature is active)
This procedure describes how to run an active menu when the preheat feature is active
- that is, when the [ready] parameter in the [setUp] function of the Configuration
mode is set to [``yes].
1. With [`idle] or time of day on the display, press the key for the menu you want to
run.
If the preheat condition has not been met, the oven will preheat until [ready]
appears on the display.
Note: You can skip preheat and go directly to the cooking sequence by pressing the menu key a second time.
If the oven is already at operating temperature [ready] will appear on the display.
2. With [ready] on the display, place the food in the oven. Then press the active
menu key (indicated by the rapidly flashing indicator light).
The menu key indicator will light up. Time will count down on the display.
The unit will run the following four-step cooking sequence:
Countdown time is displayed. It is the total of the programmed Time 1 plus Time 2
plus Time 3 plus Time 4.
Set point 1 and Fan 1 will run until Time 1 expires.
Set point 2 and Fan 2 will run until Time 2 expires. You will not see the switch-over
from Time 1 to Time 2.
Set point 3 and Fan 3 will run until Time 3 expires. You will not see the switch-over
from Time 2 to Time 3.
Set point 4 and Fan 4 will run until Time 4 expires. You will not see the switch-over
from Time 3 to Time 4.
3. When the cooking sequence is finished, one of the following will happen, depending
on the way the controller was programmed at [Etype] / [sound]:
AB
DE
C
F
GH
MINICHEF 2000
[`idle]
Edit Accept
Back-UpExit
SLOW
FLASH
AT OPERATING TEMPERATURE
(PREHEAT CONDITION MET)
RAPID
FLASH
B
DE
C
F
MINICHEF 2000
[100f`]
Edit Accept
Back-UpExit
B
DE
C
F
MINICHEF 2000
[ready]
Edit Accept
Back-UpExit
G H GH
A A
[pre-`] [`Heat]