Declaration of Conformity

Gateway Products

Watlow Winona, Inc.

1241 Bundy Blvd.

Winona, MN 55987 USA

Declares that the following product:

Model Numbers:

EM00-GATE-0000, NGW0-0000-2400 and NGW0-0000-0000*

Classification:

Communications interface card, Installation Category I, Pollution

 

degree II

Rated Voltage:

24V￿ (ac or dc) or 5V￿ (dc)

Rated Frequency:

50/60 Hz or dc

Rated Power:

10VA maximum

*NGW0-0000-0000 Requires use of a Ferrico NF130 Clamp on ferrite on all lines to pass Class B emissions. Depending on end use setup, this bead may or may not be necessary.

Meets the essential requirements of the following European Union Directives by using the relevant standards show below to indicate compliance.

89/336/EEC Electromagnetic Compatibility Directive

EN 61326:1997 With A1:1998 – Electrical equipment for measurement, control and laboratory use – EMC requirements (Industrial Immunity, Class B Emissions). EN 61000-4-2:1996 With A1, 1998 – Electrostatic Discharge Immunity

EN 61000-4-3:1997 – Radiated Field Immunity

EN 61000-4-4:1995 – Electrical Fast-Transient / Burst Immunity EN 61000-4-5:1995 With A1, 1996 – Surge Immunity

EN 61000-4-6:1996 – Conducted Immunity

EN 61000-4-11:1994 Voltage Dips, Short Interruptions and Voltage Variations Immunity EN 61000-3-2:1995 With A1-3:1999 – Harmonic Current Emissions

EN 61000-3-3:1995 With A1:1998 – Voltage Fluctuations and Flicker

Use of an appropriately approved class 2 power source is required for compliance.

Jim Boigenzahn

Winona, Minnesota, USA

Name of Authorized Representative

Place of Issue

General Manager

February 28, 2002

Title of Authorized Representative

Date of Issue

 

 

Signature of Authorized Representative

27