Waves Q-Clone manual

Q-Clone shows “No	- Q-Capture is not well	- Make sure Q-Capture
Transmission” on the	routed, is in bypass or	meters show “Transmitting”
frequency response	disabled.	and “Receiving” messages.
display.	- Signal is very low.	- Check your analog
		connections.
EQ Curve in the	Insufficient headroom	- Check clipping indicator in
frequency response	in capturing either	the Q-Capture and lower the
display does not seem	analog distortion or	headroom fader until digital
smooth or is full of	digital clipping.	clipping stops (indicator
ripples.		resets the meters by clicking
		on them with the mouse).
		- If distortion still occurs,
		lower the fader some more to
		prevent analog clipping.
EQ Curve display	Sync problem Q-Clone	- Check if you are using too
flickers or changes	is unable to lock to a	much headroom in Q-
rapidly between	valid signal.	Capture.
settings.		- Check if your device is
		valid for Q-Clone. See
		definition on page 4.
		- Try using a less extreme
		EQ setting.
		- Try closing the session and
		reopen
EQ Curve is empty.	Signal is too low.	Calibrate the Q-Clone using
		the Q-Capture component.
		See directions in Page 11.
Unstable behavior of the	EQ graphic curve look	Close the plug-in instance
Q-Clone’s EQ curves in	sluggish and unstable	first, then change the
Cubase/Nuendo after	in the Q-Clone	session’s sample rate and re-
changing the session’s	frequency response	open the plug-in.
sample rate.	display
Q-Clone mutes the	Q-Capture is capturing	Make sure Q-Clone is not
audio.	silence	bypassed, muted or poorly
		connected to the analog
		hardware device through the
		soundcard’s I/O.

Waves Q-Clone Manual 33