|
|
|
|
|
|
|
|
| GARAGE DOORS & OPENERS |
| |
|
|
|
|
|
|
| Supplemental insert |
|
| P.O. Box 67 Mt. Hope, OH 44660 | |
|
| © 2009 | |||
|
|
| |||
|
|
|
|
|
|
This supplemental installation instruction is to be used as a supplement to the main Installation Instruction and Owner’s Manual provided with the door. The instructions included in this document are only those which deviate from the standard installation. All warnings and cautions listed in the main manual are applicable to this supplemental instruction as well.
1
Tools Needed:
NONE
Routing Disconnect Cable
Thread the disconnect cable through the hole in the right hand end bracket down through the long slot in the horizontal leg of the horizontal angle. Remove all slack between opener and right end bracket.
Disconnect
cable
Torquemaster® | Hole in right |
| end bracket |
|
2
Tools Needed:
Pencil
Tape Measure
Power Drill
1/8” Bit
7/16” Socket
Driver
Routing Disconnect Cable
Mark a location on the right Jamb, 6 feet above the floor to mount disconnect handle bracket.
Align top of the handle with the mark and mark location for two lag screws.
Pilot drill lag screw location using 1/8” drill bit. Fasten bracket to the jamb with (2) 1/4” x
Hole in right end bracket
Hole in
right
side of
end
bracket
Torquemaster® Plus
Disconnect
cable
Hole in
right
side of
end
bracket
Disconnect
cable
Slot in
horizontal angle
6ft
Disconnect | (2) 1/4” X | |
handle and | ||
mounting | ||
Lag screws | ||
bracket | ||
|
1
