Wayne-Dalton 346918 installation instructions Representations of the door parts. Each specific door

Parts Breakdown

NOTE: The illustrations shown on this page are general	A2.	A1.
representations of the door parts. Each specific door	J4.
models may have unique variations.	J8.
	J6.

J7.

J7.

J1.

C1.

I2.

G2.

H3.

K2.

J8.

J3.

A1. A2.

J5.

F2.

F3.

F1.

C1.

F2. F3.

J2.F1.

E1.

E2.

E3.

G1.

H1.

B2.

B1.

I4.

H2.

Top of vertical track

3rd hole set

B2. (Quick

Top of vertical track

B1. (Fully

Adjustable

Feature)

3rd

B2.

B1.

D4.

D3.

D2.

E4.

I1.

K1.

2nd hole set

Install

Feature)

hole set

2nd hole set

I3.

C2.

C1.

D1.

	Top
1st hole	hole
	Middle
set	hole
	Bottom
	hole

1st	Lower hole
hole set	of hole/
	slot pattern

A. Flag Angles (As Required):		G1. Strut (U-shaped)
A1.	Fully Adjustable (F.A.) Flag Angles	G2. Strut (A-symmetrical)
A2.	Quick Install (Q.I.) Flag Angles	H. Drawbar Operator Bracket (For Trolley Operated Doors):
B. Jamb Brackets (As Required):		H1. Top Half Drawbar Operator Bracket
B1.	Fully Adjustable (F.A.) Jamb Brackets	H2. Bottom Half Drawbar Operator Bracket
B2.	Quick Install (Q.I.) Jamb Brackets	H3. Drawbar Operator Bracket Arm
C. Track Rollers:		I. Tracks:
C1.	Short Stem Track Rollers	I1. Left Hand Horizontal Track Assembly
C2.	Long Stem Track Rollers	I2. Right Hand Horizontal Track Assembly
D. Graduated End Hinges:		I3. Left Hand Vertical Track
D1. Single Graduated End Hinges (S.E.H.), Anti-Pinch		I4. Right Hand Vertical Track
D2. Single Graduated End Hinges (S.E.H.), Industry Standard		J. Torsion Spring Assembly:
D3. Double Graduated End Hinges (D.E.H.), Anti-Pinch		J1.	Center Bracket Bushing Assembly
D4. Double Graduated End Hinges (D.E.H.), Industry Standard		J2. Torsion Shaft
E. Stacked Sections:		J3.	Left Hand End Bearing Bracket
E1. Top Section		J4.	Right Hand End Bearing Bracket
E2. Intermediate(s) Section		J5.	Left Hand Cable Drum
E3. Lock Section		J6.	Right Hand Cable Drum
E4. Bottom Section		J7.	Right Hand and Left Hand Torsion Springs (As Required)
F. Top Fixtures (As Required):		J8.	Counterbalance Lift Cables
F1. Top Fixture Bases - (L-Shaped)		K. Rear Back Hangs:
F2. Top Fixture Slides		K1. Left Hand Rear Back Hang Assemblies
F3. Top Fixture Assemblies		K2. Right Hand Rear Back Hang Assemblies
G. Strut(s) (As Required):

2

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,

refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com