25
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
INSTALLATION
horizontal
track
Bolt must extend into the track
to serve as a roller stop
Sound framing members
Perforated angle
Perforated angle -bolted using
(2) 5/16” x 1-5/8” hex head
lag screws to ceiling members
and parallel to width of door.
Attach vertical perforated angle
between the (2) 5/16” x 1-5/8”
hex head lag screws, securing
perforated angle to ceiling
members.
horizontal
track
Perforated angle
Perforated angle - bolted using (2)
5/16” x 1-5/8” hex head lag screws
to ceiling member and parallel to
width of door. Space lag screws no
further than 24” apart.
Sound framing
members
Bolt must extend into
the track to serve as a
roller stop
24”
Rear Support Continued...
To adjust spring tension, fully close door. Apply vice
grips to track above third roller. Insert a winding bar
into the winding cone. On single spring doors, cable
tension must be maintained by placing vice grips
on torsion tube before loosening set screws in the
winding cone. Push upward on the winding bar while
carefully loosening the set screws in the winding
cone.
BE PREPARED TO SUPPORT ThE FULL FORCE OF
ThE TORSION SPRING ONCE ThE SET SCREWS ARE
LOOSE.
Carefully adjust spring tension 1/4 turn. Retighten
both set screws in the winding cone and repeat
for the other side. REChECk DOOR BALANCE DO
NOT ADjUST MORE ThAN 1/2 TURN FROM ThE
RECOMMENDED NUMBER OF TURNS.
If the door still does not operate easily, lower the
door into the closed position, UNWIND ThE SPRING(S)
FULLY (Reference the insert “Removing The Old Door/
Preparing The Opening” section on torsion spring
removal), and recheck the following the items:
1.) Check the door for level.
2.) Check the torsion tube for level.
3.) Check the track spacing.
4.) Check the counterbalance cables for equal
tension.
5.) Check the track for potential obstruction of the
rollers.
6.) Clamp locking pliers onto track and rewind
springs.
IMPORTANT: IF DOOR STILL DOES NOT OPERATE
PROPERLY, ThEN CONTACT A TRAINED DOOR SYSTEM
TEChNICIAN.
Intermediate
section
Windload
label
WARNINg