18
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed: NOTE: Refer to illustrations (A) or (B) to determine
which horizontal track was supplied with your door.
Follow the corresponding step below:
for quick install horizontal track (A): To install
horizontal track, place the curved end over the top
roller. Align the bottom of the horizontal track with the
vertical track. hand tighten the horizontal track to the
flagangle with (1) stud plate and (2) 1/4”- 20 flange
hex nuts.
for universal horizontal track (b): To install
horizontal track, place the curved end over the top
roller. Align the bottom of the horizontal track with the
vertical track. hand tighten the horizontal track to the
flagangle with (2) 1/4”- 20 x 9/16” track bolts and (2)
1/4”- 20 flange hex nuts.
DO NOT RAISE DOOR UNTIL hORIzONTAL TRACkS
ARE SECURED AT REAR, AS OUTLINED IN STEP 26,
OR DOOR COULD FALL FROM OVERhEAD POSITION
CAUSING SEVERE OR FATAL INjURY.
Level the horizontal track assembly and bolt the
horizontal angle to the slot in the flagangle using (1)
3/8”- 16 x 3/4” truss head bolt and (1) 3/8”- 16 hex
nut. Repeat for other side. Remove the nail that was
temporarily holding the top section in place, installed
in Step 16.
IMPORTANT: FAILURE TO REMOVE NAIL BEFORE
ATTEMPTING TO RAISE DOOR COULD CAUSE
PERMANENT DAMAGE TO TOP SECTION.
WARNINg
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
hammer
Flat Tip
Screwdriver
Step Ladder
Attaching flagangle to horizontal Track(2) 1/4”- 20
Flange hex
nuts
Flagangle
(1) Stud plate
q.I. horizontal track
3/8”- 16 X 3/4”
Truss head bolt
3/8”- 16
hex nut
Flagangle
horizontal angle
(2) 1/4”- 20
Flange hex
nuts
Flagangle
(2) 1/4”- 20 X 9/16”
Track bolts
Universal horizontal
track
(B)
(A)