17b | Drum Wrap Installation |
FRONT HALF
DRUM
BACK HALF
OUT BOARD
CATCH
INBOARD
SNAP
FLAGANGLE
TIGHT JOINT
APPLY PRESSURE UNDERNEATH WITH THE THUMB AND FINGERS WRAPPED OVER TOP OF SNUBBER.
FIG. 21
Locate right hand drum wrap. Slide back half of the drum wrap behind drum placing the right end wall between the drum and flag angle. Close front half of the drum wrap around drum, engage inboard snap and press firmly until a distinct snap is felt. Outboard catch must be engaged as shown. Confirm both snap and catch are fully engaged by lightly tugging against them. Repeat for the left side.
Refer back to the main door manual and continue door installation at the REAR SUPPORT INSTALLATION Step 18. (Step 19 in the Single Spring TorqueMaster™ Installation Instructions)
After door installation is completed, refer to the idrive™ owner’s manual, starting at the
NOTE: Refer to the main door manual for counterbalance adjustments. 8
REAR SUPPORT INSTALLATION
PERFORATED
ANGLE (NOT
SUPPLIED)
HORIZONTAL
TRACK
