Trim the top of each wear strip at a 45° angle as shown and clip onto the appropriate leg of each guide. Be sure that trimmed edges of the wear strips end just below the flare of the guides. Install the bottom bar stops with the same
STEP 4 INSTALL BRACKETS AND DRIVE COMPONENTS
From the Dimension Tables on page 4, mark the width location of each bracket by using dimension A for the operator side and 6” for the
IMPORTANT!
Brackets must be level to each other with respect to height. Failure to level bracket heights will prevent door from operating properly.
If the door is to be chain hoist or motor operated, install the components shown below to the operator side of the curtain at this time using the fasteners provided. Do not tighten set screws at this time, you will be instructed to tighten these in step #9.
WARNING
Keep loose clothing, fingers, hands and arms away from all moving mechanisms, or serious injury or death could result.
STEP 5 | LIFTING THE DOOR ASSEMBLY |
WARNING
Door assembly is extremely heavy. Do not allow door assembly to fall from lifting mechanism, or serious injury or death could result.
Lift door assembly up to door support brackets. Care should be taken to avoid any damage to the curtain. Make sure that the door assembly is centered between the guides and that clearance between the windlocks and the guides is the same on both sides. Adjust door assembly location as needed. Place the axle saddle castings under the axle on each
6