Operating Instructions and Parts Manual | WIP100, WIP150 |
|
|
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
Pool Pumps
Description
This swimming pool pump is designed for use with permanently installed pools only. These pools can be either
Unpacking
After unpacking the unit, carefully inspect for any damage that may have occurred during transit. Check for loose, missing or damaged parts.
General Safety
Information
This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following:
Danger indicates
an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.
Warning indicates
a potentially hazardous situation which, if not avoided, COULD result in death or serious injury.
Caution indicates
a potentially minor or moderate injury.
Notice indicates
important information, that if not followed, may cause damage to equipment.
CALIFORNIA PROPOSITION 65
This product
or its power cord may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
SAFETY GUIDELINES
1. Read these rules and
MANUAL
instructions carefully. Failure to follow these instructions could cause serious bodily injury and / or property damage.
To reduce the risk
of injury, do not permit children to use this product unless they are closely supervised at all times.
This pump
is for use with permanently installed pools. If specified, the pump may be used with hot tubs and spas. Do not use with storable pools.
A permanently installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage. A storable pool is constructed so that it may be readily disassembled for storage and reassembled to it’s original integrity.
Pump only clear water. Do not pump flammable or explosive fluids such as gasoline, fuel oil, kerosene,
etc. Do not use in a flammable and/or explosive atmosphere. Personal injury and/or property damage could result.
All wiring must be performed by a qualified electrician. The pump must be installed in compliance with all local
codes and the National Electrical Code.
2.Do not install within an outer enclosure or beneath the skirt of the hot tub or spa, unless so marked.
READ & FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
Installation
LOCATION
Disconnect, tag and lock out power source before attempting to install, service,
relocate or perform any maintenance.
Locate pump as close to pool/spa as possible. Install the pump on a hard, level surface that is dry, well ventilated and away from direct sunlight. The surrounding area should provide protection from the elements and ample room for maintenance and service. Ensure the drainage will flow away from the pump.
Above ground pool pumps are not
Inground pool pumps are self- priming. Mount pump below water level for easy priming. If the pump must be located above the filled water level, keep the vertical distance to a minimum.
GENERAL PLUMBING
SOLVENT WELD CONNECTIONS
Use rigid or flexible PVC pipe. Ensure pipe ends are clean and free of any flash caused by the cutting operation. Use the proper adhesive for the type of pipe specified. See list of recommended adhesives on page 2.
NOTE: Use an adhesive primer to ensure adhesive joints are secure. Suregard
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
© 2010 WAYNE Pumps | For parts, product & service information | |
| visit www.waynepumps.com |
|