Weber 200, 100, LP GAS GRILL Maintenance, Burner Tube Cleaning Or Replacement, Burner Tube Removal

MAINTENANCE

BURNER TUBE CLEANING OR REPLACEMENT

You will need: a flathead screwdriver..

A) Your Weber® Q® barbecue must be OFF and cool..

B)Turn gas OFF at source..

C)Open the lid..

D) Remove cooking grate..

Burner Tube Removal		1
A)	Remove the ¼-20 x ½ inch screw that holds the burner tube to the cookbox (1)..
B)	Carefully slide the burner tube out from the cookbox..

Burner Tube Cleaning

A) Look inside the burner with a flashlight (2)..

B) Clean the inside of the burner with a wire (a straightened-out coat hanger will work) (3)..

C) Check and clean the air shutter opening at the ends of the burner.. Check and clean the valve orifice at the base of the valve.. Use a steel bristle brush to clean outside of burner.. This is to make sure all the burner ports are fully open..

m CAUTION: Do not enlarge the burner ports when cleaning.

D) Lightly tap each burner to get debris and dirt out of the burner tube.. Once the spider/insect screens and burners are clean, reinstall the burners..

Burner Tube Reinstallation

A) To reinstall the burner tubes, reverse steps for “Burner Tube Removal” as previously described..

m CAUTION: The burner openings (4) must be positioned properly over the valve orifices (5).

m WARNING: After reinstalling the burners, the gas connections should be leak checked with a soap and water solution before using the barbecue. Refer to “CHECK FOR GAS LEAKS.” ◆

5

4

2

3

www.weber.com® 15