Step 4
SIDE BURNER GAS CONNECTIONS
MODELS WITH A BRASS CAP:
Using two adjustable wrenches, remove the brass cap from the side burner fitting. Figure 2.
nCAUTION: When removing the cap “hold” the side burner fitting to keep it from becoming loose. If the side burner fitting should loosen, tighten before attaching side burner hose.
Note: After you complete this step, skip Steps 5 and 6 and please go onto Step 7.
Side burner fitting
Brass cap
Figure 2
MODELS WITH A BLACK SQUARE PIPE PLUG:
Using an adjustable wrench, remove the pipe plug from the manifold. Figure 3.
Black pipe plug
Figure 3
MODELS WITH A BRASS SQUARE PLUG:
Using an adjustable wrench, remove the pipe plug from the manifold. Figure 4.
Brass square plug
Figure 4
Step 5
FOR MODELS THAT USE THE ENCLOSED BRASS FITTING
Apply pipe sealant to only the area indicated. Figure 5.
nWARNING: Use a pipe sealant compound on the threads that is approved for natural or LP gas.
Only use pipe sealant here
NO pipe 
sealant here
Figure 5
Screw the fitting into the manifold using the 5/8 inch wrench. Figure 6(a).
Figure 6(a)
OR
Screw the fitting into the brass plug elbow. Figure 6(b).
Figure 6(b)
2
