Side Burner Maintenance
nWARNING: All gas controls and supply valves should be in the OFF position.
Check igniter: Remove side burner cover. To remove side burner cover, remove control knob and screws that hold cover to bottom. Figure 14. Make sure wire is connected between igniter and electrode. Check that igniter lock nut is tight. Figure 15.
Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.
Venturi/Burner
Igniter wire Electrode
Adjust igniter electrode. Gap should be 1/8 to 3/16 inch | Igniter | |
from tip of electrode to burner. Figure 16. Spark should be | Figure 15 | |
a white/blue color, not yellow. | ||
|
1/8 to 3/16 inch gap
Figure 14
Figure 16
7