Position slide bar assembly on the outside of the caster frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 33.
Notch to the front
Slide bar
View from front of barbecue
Step 26
Complete accessory installation
You will need: work table, accessory rack,
Insert one end of the Weber
Set the work table onto the left side rails. Figure 35 (b).
Set the accessory rack between the two frame connectors. Figure 35 (c).
Set the warming rack into the slots at the rear of the cooking box. Figure 35 (d).
Insert the thermometer into its holder. Figure 35 (e).
Insert tubing plugs into the ends of the frame. To fully seat the plugs, you may have to tap them lightly with a hammer. Figure 35 (f).
Figure 33
To lower table: Pull support rod up to disengage slide lock, and lower table. To raise table, lift table up and engage slide in locked position. Figure 34.
(a)
(d)
(e)
(b)
Support rod |
|
View from rear | (f) |
| |
of barbecue | (c) |
|
Slide
Figure 35
mCAUTION: To keep the barbecue stationary, the tabs on the locking casters should be in the down position.
Unlocked position | Locked position |
Figure 34
23
