Weber 3500 owner manual To reinstall the burners, reverse steps c through g

d)Unlatch the Spider Stopper Guards and remove. Figure 11.

Figure 11

e)Disconnect gas supply line and side burner.

f)Remove the manifold bracket and unscrew the two wing nuts that hold the manifold to the cooking box. Pull the manifold and valve assembly out of the burners and carefully set it down. Figure 12.

View from behind cooking box

Wing nuts

Figure 12

g)Slide the burner assembly out from under the guide screw and washer in the corners of the cooking box. Figure 13.

Guide screw

Figure 13

h)Lift and twist the burner assembly slightly, to separate the crossover tube from the burners. Figure 14. Remove the burners from the cooking box.

Crossover tube

Figure 14

i)To reinstall the burners, reverse steps c) through g).

mCAUTION: The burner openings must be positioned properly over the valve orifices. Figure 15 (a).

Check proper assembly before fastening manifold in place. Figure 15 (b).

Burner opening

(a)

Valve orifice

(b)

Figure 15

j)Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the Venturi fins. There should be no gaps in the seams or in the fit around the burners and valves. Figure 16.

Check fit around valve

Venturi fin

Check fit around burner

Figure 16

mCAUTION: If the Spider Stopper Guards do not fit tightly, contact Weber-Stephen Customer Service.

k) Reconnect gas supply line. See “Check for gas leaks”.

34