Weber 41081 manual To Clean the Burner Head To Reassemble the Burner Head

To Clean the Burner Head		To Reassemble the Burner Head
Remove the windshield and grate. Remove the burner		Insert the burner head into the burner base. Figure 19
cap. Clean with soap and water. Soak if necessary.		(c). There is a hole in the burner head for the igniter
Remove the burner ring. Clean with soap and water.		electrode.
Soak if necessary.		Set the burner ring onto the burner head. Rotate the
mCAUTION: Do not enlarge the slots in the burner		burner ring until the four lugs on the burner ring are
ring. Only clean with a cloth and soap and water.		seated in the four slots on the burner head. Figure 19
Remove the burner head. Clean with soap and water.		(b).
Soak if necessary.		mWARNING: If the flame pattern is uneven or
Wipe out the burner base with a damp cloth and soap		erratic, turn OFF the burner control knob. Check
and water.		the position of the burner ring to the burner head.
mCAUTION: Avoid getting water or dust in the		The lugs of the burner ring must be in the slots of
burner orifice.		the burner head.
Clean the ignition electrode with a damp cloth and		Install the burner cap. Figure 19 (a). Install the grate
soap and water.		and the windshield.
1)	Windshield
2)	Grate	1)	Windshield
3)	Burner Cap	2)	Grate
4)	Burner Ring	3)	Burner Cap
5)	Lug	4)	Burner Ring
6)	Slots	5)	Lug
7)	Burner Head	6)	Slot
8)	Igniter electrode	7)	Burner Head
9)	Burner Orifice	8)	Igniter Electrode
10)	Burner Base	9)	Burner Base
		10)	Burner Orifice
	(3)
(1)			(1)

(2)

(4)	(2)
(5)
(6)
	(3)
(7)	(4)
(8)	(5)
	(6)
(9)	(7)
(10)
	(8)
	(9)
	(10)
	Burner assembly consists of: burner cap, burner ring,
	burner head, burner base, and burner orifice.
	Note: The burner head has a hole in it that fits over
	the igniter electrode.

D-16