Weber Built In LP Side Burner, 42376 Built-Ingas Line Locations, General Construction Details

GAS INSTRUCTIONS 5

BUILT-IN GAS LINE LOCATIONS

GENERAL CONSTRUCTION DETAILS

•Summit® Built-In side burner unit should be on site before construction begins.

•All dimensions have a tolerance of plus or minus +/- 1/4” inch.

Provide access for a corrugated gas line depending on the location of the side burner in relation to your main gas supply and regulator position.

Area should be kept clear of sharp, jagged, or extremely abrasive surfaces to avoid possible damage to gas supply lines. Exercise caution when pulling gas lines through built-in structure.

A 3/8 “ inch stainless steel corrugated gas line should be used to connect the side burner to the regulator accessory coupling.

WARNING: Do not use a rubber gas hose.

TEST CONNECTIONS

All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of ANSI Z223.1/NFPA 54.

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for gas leaks. This will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.

Be sure to secure the side burner unit with non corrosive screws anchored into the finished surface of the “island structure”.

Replace the plastic plug on the front mounting hole to conceal the screw once side burner is secure.

 3!% STAINLESS CORRUGATEDGAS LINE

4YPICAL TANKL CABINETILOCATION

MOUNTING THE SIDE BURNER

Connect the corrugated gas line to the side burner valve located on the back right hand side of side burner.