Weber 42377 Gas Instructions, Side Burner, Cut out Dimensions, Tolerances, + 1/4 - 1/4, 3 3/4

GAS INSTRUCTIONS

LOCATING YOUR BUILT-IN SIDE BURNER

When determining a suitable location for your Built-In Side Burner installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the Summit® Built-In Side Burner in a garage, breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the Side Burner and structure so there is enough room to safely evacuate the area in case of a fi re.

CLEARANCE FROM COMBUSTIBLE SURFACES OR STRUCTURES

WARNING: Clearance from the outside walls of the sides and back of the LP Tank Cabinet must be a minimum of 24 inches any surface. Refer to “Typical Gas Supply Installation” before starting installation.

WARNING: The structure, “island” counter tops and adjacent work areas for the LP Tank Cabinet installation must be built from noncombustible materials only.

NOTE: If you have questions on what materials are con- sidered noncombustible, contact you local building supplier or fi re department.

Any Surface 24 inches

24 inches min. for lid clearance

24 inches Any Surface
	24inches	Any
Side		Surface
Burner

Note: For a countertop

treatment: Recommended 3/4 inch overhang. Notch front edge for frame to fully slide in.

BUILT-IN SRUCTURE CUTOUT DIMENSIONS All dimensions are to finished surfaces.

WARNING: All counter top finished surfaces must be constructed of a noncombustible material.

Side Burner

	Cut out Dimensions	Tolerances
A	10 12"	+ 1/4" - 1/4"
B	3 3/4"	+ 1/4"	- 1/4"
C	16 1/4"	+ 1/4"	- 1/4"

4