Weber 42377 manual Connect Gas Supply, Regulator, Gas Instructions, Test connections, Danger

GAS INSTRUCTIONS

TEST CONNECTIONS

All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of the National Fuel Gas Code ANSI Z223.1/NFPA 54.

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for gas leaks. This will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.

REGULATOR

•The regulator should be adequately supported.

•The regulator must be installed close to the appliance.

•Each appliance must have a separate regulator.

CONNECT GAS SUPPLY

1)Uncap the fl are fi tting from the optional side burner connection located at regulator.

Note: You must connect your side burner to a Weber® approved regulator(part number #62434) located at main gas supply. If you do not use a Weber® approved regulator the Warranty on the Summit® Built-In Side Burner will be voided.

If you have any questions, contact Customer Service at 1-800-446-1071

2)Connect the corrugated gas line to the side burner Connection.

top view

Cap (Optional Side Burner)

Hard piped gas supply

Figure 1

Regulator

top view

Hard piped	to side burner
gas supply

Test connections

All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of ANSI Z223.1/NFPA 54.

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for gas leaks. This will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.

WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.

Note - All factory-made connections have been thoroughly checked for gas leaks. As a safety precaution however, you should recheck all fi ttings for leaks before using your Summit® Built-In side burner. Shipping and handling may loosen or damage a gas fi tting.

You will need: a soap and water solution, and a rag or brush to apply it.

Turn on gas supply.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows, there is a leak.

Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

WARNING: Do not ignite burners when leak check- ing.

Regulator

Figure 2

7