GAS INSTRUCTIONS
BUILT-IN GAS LINE LOCATIONS
GENERAL CONSTRUCTION DETAILS
•Summit®
•All dimensions have a tolerance of plus or minus +/- 1/4” inch.
Provide access for a corrugated gas line depending on the location of the side burner in relation to your main gas supply and regulator position.
Area should be kept clear of sharp, jagged, or extremely abrasive surfaces to avoid possible damage to gas supply lines. Exercise caution when pulling gas lines through
A 3/8 “ inch stainless steel corrugated gas line should be used to connect the side burner to the regulator accessory coupling.
WARNING: Do not use a rubber gas hose.
Test connections
All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of ANSI Z223.1/NFPA 54.
DANGER
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for gas leaks. This will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.
Be sure to secure the side burner unit with non corrosive screws anchored into the fi nished surface of the “island structure”.
Replace the plastic plug on the front mounting hole to conceal the screw once side burner is secure.
3/8" SAE stainless |
corregated gas line |
to regulated gas supply
MOUNTING THE
SIDE BURNER
Connect the corrugated gas line to the side burner valve located on the back right hand side of side burner.
5
