Step 4
Continue frame assembly
You will need: frame assembly, wheel frame assembly, front panel, caster frame, four
Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel frame onto the tabs of the right frame with the dimple to the inside. The fuel scale decal should face away as shown. Figure 3.
The leg tabs must be on the inside of the frames.
Add front panel with the hole down and to your right. Add the washers to the bolts, insert in the holes as shown. Only start the bolts at the wheel frame, figure 3 (a) & (b), and tighten the bolts at the caster frame.
Note - Fuel scale decal on wheel frame must be on the same side as the front panel.
Dimples to the inside
Fuel scale decal
Only start this bolt
Figure 3
Step 5
Complete frame assembly
You will need: partial frame assembly, one frame connector with bushings, one frame connector without bushings, four
Hold the frame connector, bushing side down, between the caster and wheel frame, above the front panel. Add nylon washers to the bolts, put the bolts through the frame and screw into the frame connector. Tighten.
The second frame connector has no bushings, place it between the caster frame and the wheel frame. Add a nylon washer to the bolt, put the bolts through the frame and screw into the frame connector. Tighten. Figure 4.
Bushings down
Figure 4
12
