Step 9
Install the three back panels
You will need: frame assembly and the three back panels. (Number 2)
Place the bottom of one back panel on the back frame connector, notches to the top. Set in place to the far left, butting up against the caster frame. Figure 8.
Figure 8
Repeat the procedure with the other two back panels. When in place they should be flush with each other.. Figure 9.
Wheel frame
Caster frame
Figure 9
Step 10
Install side burner locks
You will need: frame assembly, two side burner locks and a 7/16 inch wrench.
Loosen the right rear 1/4 x 20 bolt. Install the side burner lock. The “U” shape cut out of the lock slips down over the bolt. Tighten with a wrench. Figure 10 (a).
Loosen the right front 1/4 x 20 bolt. The side burner lock fits between the front panel and the frame.
The “U” shape cut out slips up over the bolt. Tighten with a wrench. Figure 10 (b).
(a)
(b)
Figure 10
14
