![](/images/new-backgrounds/1256377/25637743x1.webp)
4.) While holding
5.) Add a washer to each bolt and insert it through the hole in the frame and the hole in the trim piece on both sides. Tighten with a wrench.
To raise
To lower
Do not use the work surface as a cutting board.
Install the work surface
You will need: work surface.
Place the work surface, so that the front and back edges fit over the frame, in the area between the left trim piece and the cooking box as shown.
Do not use the work surface as a cutting board.
(1)
(1)Make sure that the tabs on the side table are to the right, next to the cooking box.