Add fuel gauge
You will need: fuel gauge, two wing nuts and two nylon washers.
1)Slip the bolts on the back of the fuel gauge through the two small holes in the cylinder panel.
2)Add washers to the bolts, then wing nuts, and tighten with your fingers.
(1) | (2) |
Install igniter
Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.
The igniter lock nut is on the igniter.
1)Loosen the igniter lock nut.
2)Insert the top of the igniter up through the large part of the keyhole in the frame brace. Slide the igniter into the small part of the keyhole.
3)Tighten the igniter lock nut back onto the igniter. Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.
(1)
(2)
(3)
