One Ethernet port supporting 10BaseT or 100BaseT
operation, RJ-45-switched
Interface ports
See Power supply information on page 4.
Power supplies and power requirements
Power supply informationThe power supply is included in the satellite modem shipping carton.
Figure 5: Power supply for the HN9000 satellite modem
Before proceeding, make sure you have the correct power supply.Check the part number on the power supply and refer
to Table2: Power supply specications for the HN9000 satellite modem on page 4.
• Always use the power supply provided with the satellite modem. The modem's performance may sufferif the wrong
power supply is used.
• The input must be 110/130 VAC.
• Asuitable surge protector is recommended to protect the satellite modem from possible damage due to power surges.
• Ifthe satellite modem is installed outside the United States or Canada, observe the power standards and requirements
of the country where it is installed.
Table 2: Power supply specifications for the HN9000 satellite modem
Power cordElectrical requirementsApplication
Power supply type and part
number
Detachable, for 110
VACoutlet type.
Input line voltage:
100 – 130 V,2 A maximum
HN9000 satellite modem
with 1-W or 2-W radio
AC/DC, 73 W
P/N 1501006-0001
Input line frequency:
60 Hz AC
Ratedpower consumption: 73 W
Note: The satellite modem should be continuously powered on unless it will not be used for an extended period.
4
Satellitemodem overviewHN9000Satellite Modem UserGuide –
1037577-0001Rev. A
Chapter1