Chapter 2

HN9000 Satellite Modem User Guide –

System Control Center

 

1037577-0001 Rev. A

 

Addressing – Contains addressing information such as LAN port address and subnet mask and available public IP addresses (if any, depending on your service plan).

Software Features – This section lists the optional features and provides information on whether they are currently active. These features are enabled or disabled per your service plan and cannot be changed locally.

State codes

A state code is a number that indicates the operational state of the satellite modem. Some state codes indicate an error condition. State codes are identified as State code followed by a number from 1 – 35. They are displayed with an explanation in words, as shown in the following example.

State codes appear on screens displayed during a hard reboot (when power is removed and then restored) and on System Control Center pages.

Figure 19: Examples of state codes

Table 5: State codes on page 20 lists and explains all HN9000 state codes.

In the state code table, modem refers to the satellite modem.

Table 5: State codes

State code

State name

Explanation

Corrective action

 

 

Installation – Boot phase

 

1

Starting Up in Boot

Satellite modem is starting up in boot

Transient – No action is necessary.

 

 

phase.

 

2

Waiting for Installation

Modem has not been installed, and

Transient – No action is necessary.

 

Parameters

installation parameters have not been

 

 

 

submitted.

 

3

Coarse Pointing in

Antenna pointing is in progress

 

Progress

(coarse or fine pointing). Occurs

 

 

during modem installation only.

Transient – No action is necessary.

4

Acquiring Beacon in Boot

Occurs during Auto modem

Transient – No action is necessary.

 

 

replacement only: Modem is searching

 

 

 

for beacon.

 

5

Acquiring PTP SNR in

Occurs during Auto modem

Transient – No action is necessary.

 

Boot

replacement only: Modem is searching

 

 

 

for point-to-point signal.

 

6

Waiting for Uplink

Modem is waiting for installer to

Installer should switch polarization.

 

Polarization Change

switch uplink polarization at the radio

 

 

 

assembly. Occurs during installation

 

 

 

only.

 

20

Page 34
Image 34
Hughes HN9000 manual State codes