Operational and safety requirements for Canada
In addition to the warnings and safety guidelines listed in this document, the following operating conditions apply to
the modem when used in Canada:
The Canadian Department of Communications label identies certied equipment. This certication means that the
equipment meets certain telecommunications network protective operational and safety requirements. The Department
does not guarantee that the equipment will operate to the user’s satisfaction.
Before installing the equipment, users should make sure they are permitted connect to the facilities of the local
telecommunicationscompany. The equipment must also be installed using an acceptable method of connection. In some
cases, the company's inside wiring associated with a single line individual service may be extended by means of a
certied connector assembly (telephone extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.

Repairs in Canada

Repairsto certied equipment should be made by an authorized Canadian maintenance facility designated by the supplier.
Anyrepairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility,telephone lines,
andinternal metallic water pipe system, if present, are connected together. This precaution may be particularly important
in rural areas.
Usersshould not attempt to make electrical ground connections themselves, but should contact the appropriate electrical
inspection authority,or electrician, as appropriate.
Electromagnetic interference (EMI)
Thisproduct conforms to EMI standards of the U.S. FCC and Canadian CSA. To ensure compliance with these standards,
installers and users must follow the installation, maintenance,and conguration procedures in the installation guide and
user guide.
This is a class B product. In a domestic environment this product may cause radio interference in which case the user
may be required to take adequate measures.

FCC Part 15

This section applies to the HN9000 satellite modem.
Standards to which Conformity is declared: FCC Part 15
The modem complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
devicemay not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Responsible party’sname: Hughes Network System, LLC
62
Conformancewith standards and directivesHN9000Satellite Modem User Guide –
1037577-0001Rev. A
Chapter8