FOR YOUR SAFETY READ BEFORE LIGHTING 
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury, or loss of life.
A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance
Do not touch any electric switch;
do not use any phone in your building.
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to slide the gas control switch Never use tools. If the witch will not slide by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
OPERATING INSTRUCTIONS
1.STOP! Read the safety information above on this label.
2.Set the thermostat or operating control to lowest setting.
3.Turn off all electric power to the appliance.
4.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
5.If the gas valve is not visible, remove control access panel.
6.If the gas control switch is not in the "OFF" postion, slide the switch to "OFF".
7.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above on this label. If you don't smell gas, go to the next step.
8.Slide the gas control switch to "ON".
9.Replace control access panel, if applicable.
10.Turn on all electrical power to the appliance.
11.Set thermostat or operating control to desired setting.
12.If the appliance will not operate, follow the instructions "To Turn Off Gas To Appliance" and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE 
1.Set the thermostat or operating control to lowest setting.
2.Turn off all electric power to the appliance if service is to be performed.
4.Slide the gas control switch to "OFF".
5.Replace control access panel, if applicable.
3. If the gas valve is not visible, remove the control access | SV9501/SV9601 9318 REV 2 (MM/YY) | |
access panel. | ||
|
Figure 7.3: Operating Instructions
24
