BURNER IGNITION & USAGE
BURNER IGNITION –
Lighting with a Match
A) Open the grill lid (1).
mDANGER
Failure to open the lid before igniting the grill’s burner, or not waiting five minutes to allow the gas to clear if the grill does not light, may result in an explosive
B) Unfold the side tables (2) (Q® 1200, Q® 2000,
Q® 2200).
C) Make sure the burner control knob is turned to the off
| ( ) position (3). Check by pushing burner control knob |
| in and turning it clockwise until it stops. |
D) | Confirm that the cylinder is properly installed. Refer to |
| “INSTALLING THE LP CYLINDER.” |
E) | Strike a match and put the flame under the matchlight |
| hole (4). While holding lit match, push burner control |
| knob in and turn it counterclockwise to start/high ( ) |
| position (5). |
F)Check that the burner is lit by looking through the cooking grates (6). You should see a flame.
mWARNING: Do not lean over the open grill while igniting. Keep your face
and body at least 12 in (30 cm) away from the matchlight hole when lighting the grill.
m WARNING: If the burner fails to ignite within five seconds, stop, turn the burner control knob to off and wait five minutes to allow the gas to clear before you try again.
TO EXTINGUISH BURNER
Push burner control knob in and turn it clockwise to the off ( ) position.
m CAUTION: Do not fold in side tables until grill is cold (Q® 1200, Q® 2000, Q® 2200).
WWW.WEBER.COM® 15