Weber 625 manual Mount Regulator Bracket, ADD Right Panel

MOUNT REGULATOR BRACKET

You will need: two 1/4-20 x 1/2 inch bolts, two nylon washers, two 1/4-20 keps nuts, and a 7/16 inch or open end wrench.

Position the top of the regulator bracket over the top crosspiece. Slip a washer over the bolt and insert through top of bracket and crosspiece. Add keps nut. Repeat with second bolt. Tighten. Figure 4.

Figure 4

Crosspiece

View from below front

ADD RIGHT PANEL

FOR THE SUMMIT 450 & 650

You will need: right panel and two plastic plugs.

Set the right panel in place. The top flange of the panel fits over the top crosspiece. The bottom curved flange fits under the bottom crosspiece. Figure 5.

Top	Top
crosspiece	flange

Bottom

crosspiece

Curved flange

Figure 5

Once the panel is in place, push in the two plastic plugs through the panel into the top crosspiece. Figure 6.

Figure 6

5