20 | Operating Instructions |
|
MANUAL LIGHTING
DANGER
Failure to open the lid while igniting the barbecue’s burners, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive
1)Open the lid.
2)Make sure all burner control knobs are turned OFF. (Push each knob in and turn clockwise to ensure they are in the off position.)
WARNING: The burner control knobs must be in the OFF position before turning on the liquid propane cylinder valve. If they are not in the OFF position, when you turn on the LP cylinder valve, the “excess gas flow control” feature will activate, limiting the flow of gas from the LP cylinder.
If this should occur, turn OFF the LP tank valve and burner control knobs. Then start over.
DANGER
When the “excess gas flow control” feature is activated, a small amount of gas is still flowing to the burners. After turning OFF the cylinder and burner control knobs, wait at least 5 minutes for the gas to clear before attempting to light the barbecue. Failure to do so may result in an explosive
3)Turn the cylinder on by turning the cylinder valve counterclockwise.
4)Strike a match and put the fl ame into the matchlight hole under the igniter.
WARNING: Do not lean over open barbecue when lighting the barbecue.
5)Select Outside burner, push control knob in and turn to START/HI.
6)Check that the burner is lit by looking down through the cooking grate. You should see a fl ame.
WARNING: If the burner does not light, turn the burner control knob to OFF and wait 5 minutes to let the gas clear before you try again.
7)After the Outside burner is lit you can turn on the Inside burner. The Inside burner is ignited from the Outside burner.
A | B | C | D |
TO EXTINGUISH
Push down and turn each burner control knob clockwise to the OFF position. Turn gas supply OFF at the source.
