KETTLE ROTISSERIE
INSTRUCTIONS
IMPORTANT SAFEGUARDS
mWARNINGS
3. Attach the Counterweight to the Rotisserie Shaft
Unscrew the retaining loop, put the counterweight assembly in place, reattach the retaining loop.
• Read all instructions before using your rotisserie. | |
• | This rotisserie is for outdoor use only. |
• | Remove motor and store in a dry place when |
| not in use. |
Handle of shaft
Travel
• Do not touch hot surfaces. Use barbecue mitts. |
• This rotisserie is not for use by children. |
• To protect against electrical hazards do not immerse |
cord, plugs, or motor in water or other liquids. |
• Unplug the motor from outlet when not in use, or before |
cleaning |
• Do not use rotisserie for other than intended use. |
• Make sure motor is off before placing it on the |
motor bracket. |
• Do not operate the rotisserie motor with a damaged |
cord or plug. |
• Do not operate the rotisserie motor if it |
should malfunction. |
• The rotisserie motor is equipped with a three prong |
(grounding) power cord for your protection against |
shock hazard. |
• The power cord should be plugged directly into a |
properly grounded three prong receptacle. If use of an |
extension cord is required, be sure that it is a minimum |
16 AWG, 3 wire well insulated cord, marked for |
OUTDOOR USE ONLY and properly grounded. |
• When using an extension cord, make sure it is not in |
contact with hot or sharp surface. |
• Outdoor extension cords should be marked with the |
letters |
outdoor appliances”. |
• Do not cut or remove the grounding prong from the |
rotisserie motor power cord. |
• Do not let cord hang over any sharp edge or |
hot surface. |
• Use only outdoors, do not expose to rain. |
• To reduce the risk of electric shock, keep extension cord |
connection dry and off the ground. |
• A short power cord is supplied to reduce the risk of |
tripping over the cord. Extension cords may be used, but |
caution must be taken to prevent tripping over the cord. |
SAVE THESE INSTRUCTIONS
Assembly
1. Install Rotisserie Ring
Place the enameled rotisserie ring inside the kettle so that the tabs rest on the top edge of the kettle.
2. Attach the Motor
Slide the motor onto the Stainless Steel motor bracket.
Retaining loop
Counterweight 
Counterweight 
assembly
4. Put the Spit Forks on the Rotisserie Shaft
Slide the forks onto the shaft so that the tines are facing each other. Screw in the thumb screws to hold the forks in place.
5. Insert the Rotisserie Shaft in the Motor
Insert the pointed end of the rotisserie shaft into the motor.
96811 10/98
