MAIN BURNER IGNITION & USAGE

METHODS OF BURNER IGNITION

There are two ways to ignite burner 1. The first is by using the electronic Crossover® ignition system built into your grill. The second is with a match.

Next are the steps for igniting your grill using the electronic Crossover® ignition system.

On the following page are steps for igniting your grill with a match.

Summary lighting instructions are inside the cabinet door.

Some batteries have a plastic protective wrap around them. This plastic must be removed before you attempt to ignite your grill with the electronic Crossover® ignition system. Do not confuse this plastic with the battery label.

MAIN BURNER IGNITION

Electronic Crossover® Ignition System

The electronic Crossover® ignition system ignites burner 1 with a spark from the igniter electrode inside the Gas

Catcher™ ignition chamber. You generate the energy for1 the spark by pushing the igniter button. You will hear the

igniter clicking. Burner(s) 2 (and 3) can be lit after burner 1 is lit.

A) Open the grill lid (1).

m DANGER

 

Failure to open the lid before igniting

 

the grill’s burners, or not waiting five

 

minutes to allow the gas to clear if the

 

grill does not light, may result in an

2

explosive flare-up which can cause

serious bodily injury or death.

 

B) Make sure ALL burner control knobs are turned off

(2). Check by pushing control knobs in and turning them clockwise until they stop.

C) Turn the gas supply valve on (3).

D)Push burner 1 control knob in and turn it counterclockwise to start/high ( ) position (4).

 

IMPORTANT: Always ignite burner 1 first. The other

 

 

burner(s) ignite from burner 1.

 

E)

Push and hold in the igniter button (5). You will hear

 

 

the igniter clicking.

 

F)

Check that burner 1 is lit by looking through the

 

 

cooking grates. You should see a flame.

3

m WARNING: Do not lean over the open

 

 

grill.

 

m WARNING: If burner 1 fails to ignite

 

 

within five seconds, stop, turn the

 

 

burner control knob to off and wait

 

 

five

minutes to allow the gas to clear

 

 

before you try again or light with a

 

 

match.

 

G)

After burner 1 is lit, you can turn on burner 2 (and

 

 

burner 3).

4

TO EXTINGUISH BURNER

 

Push each burner control knob in and turn it clockwise to

 

the off (

) position. Turn gas supply off at the source.

 

5

16WWW.WEBER.COM®

Page 16
Image 16
Weber SP310, E210, E310 manual Main Burner Ignition & Usage, Methods of Burner Ignition, To Extinguish Burner